VapeCon starter kits reviews: tested in Austria (Vanilla Custard) (v2)

VapeCon starter kits advice for Austria, covering DIY liquids, what to look for and where the trade-offs actually sit.

The Austria market for vapecon starter kits has grown steadily, and the choice on offer now is genuinely broad. The instruction booklet is thin, but the diagrams are clear enough that most people set the device up without further help.

Anyone who has compared vapecon starter kits options in Austria quickly learns that specification lists only tell part of the story. The Matte Sand finish hides fingerprints far better than the gloss options, which matters more than it sounds on a device handled daily.

Replacement coils are widely available, and the 1.2 Ω mesh coil is the sensible default to keep in stock. The included spare coils are useful for the first fortnight, after which you will be ordering your own. What surprised us most was how little the 1.2 Ω mesh coil changes the draw character compared with the 50:50 PG/VG liquid sitting in the chamber.

Materials are unremarkable on paper and feel reassuringly solid in the hand, with no flex in the body at all. The instruction booklet is thin, but the diagrams are clear enough that most people set the device up without further help. Flavour tracking stays consistent from the first day to roughly the 1.2 Ω mesh mark before the profile flattens and a swap makes sense.

Worth noting that the 510 bottom pin takes a small amount of care to keep clean, which we cover in the maintenance section below. For diy mixers, the learning curve is shorter than the specification list suggests, and daily use is straightforward from the first charge. Flavour tracking stays consistent from the first day to roughly the 1.2 Ω mesh mark before the profile flattens and a swap makes sense.

Two things to check before ordering: the Type-C fast charge socket on the base and whether the 1.2 Ω mesh coil is the newer generation. Battery behaviour is where the Deng SQ200 earns its keep: the 3000 mAh cell holds a usable charge for most of a day at 150 and recharges over Type-C fast charge. If you take one thing from this page, make it the coil compatibility check. A device that needs a coil you cannot source locally becomes an expensive ornament within a month.

The 3.0 ml capacity is a genuinely useful middle ground: enough liquid for a long session without turning the device into a pocket problem. We would pair the Deng SQ200 with a 50:50 PG/VG liquid, which is where the balance between throat hit and cloud density sits most comfortably. In Austria, availability of the 1.2 Ω mesh coil is the practical bottleneck, not the device itself.

Comparing this against a 50:50 PG/VG setup shows the difference clearly: one favours flavour, the other favours volume. Vapour production is more than adequate at 150, and pushing beyond that adds heat rather than anything worth carrying. Expect roughly 1789 full puffs from a charge at 0 mg/ml, based on average session length in our testing.

Specifications

These are the figures that matter day to day, and the ones worth comparing across models.

Flavour and performance notes

A representative profile is Lemon Lime Soda: citrusy, crisp, described as zesty lemon over lime with gentle carbonation. On a 50:50 PG/VG ratio this reads clearly on the first day and holds its character to roughly the 1.2 Ω mesh mark before the coil begins to mute it.

Practical considerations in Austria

Availability in Austria is the factor that decides most outcomes here. Confirm the 1.2 Ω mesh and the Type-C fast charge are both in stock before committing, and check that the 510 bottom pin matches your existing device if you already own hardware. Duty and EUR rates move, so treat prices as current rather than fixed.

If you would rather talk it through, use the contact details below and we will answer directly.